Allowlist, Add, and Manage Targets

Targets are domains that you add to the allowlist so that you can include them in apps and scans. Application Security targets the domain for the attacks in the scan configuration to test for vulnerabilities.

To add apps and configure and run scans, you must add targets to the allowlist. To keep the allowlist clean and the list of active targets up to date, manage existing targets.

Removing targets

To make it easier to find relevant targets, keep your allowlist clean by removing targets that you don’t need anymore. You can archive and disable previously scanned (used) targets and delete and disable unused targets.

Check out our FAQ for more information on allowlists and targets.

Add a target to the allowlist

Allowlisting target domains is a critical step for creating a scan config. Only the domain is required for adding to the allowlist. Protocols and subdirectories will be removed during scanning.

  1. On the Targets page, click Add Targets.
  2. When the Add Targets page appears, input one or more target domains you want to allowlist.
    • Enter a domain in URL format: protocol://subdomain.domain.com/subdirectory
    • To bulk add multiple target domains, enter each domain on a new line.
  3. Click Add Targets.

All newly allowlisted target domains are enabled by default, unless configured otherwise.

Manage existing targets

When you’re not using a target domain anymore and want it excluded from scans, you can disable and enable or archive as needed. If you attempt to add a disabled or archived target domain, you will be prompted to allowlist it. If you have a target domain that hasn’t been scanned, you can delete it.

Check scan configs

If you are disabling or archiving a target domain, existing scan configs that use it may be affected. Check your scan configs to ensure that the target domains can be taken offline.

Frequently asked questions